Instruction Manual

Instruction Manual
12
KGS Corporation
1.7 Test print
Print following four lines as test print.
⠀⠀⠧⠑⠗⠎⠊⠕⠝⠀⠼⠃
⠀⠀⠉⠒⠤⠛⠭⠶⠿⠀⠉⠒⠤⠛⠭⠶⠿⠀⠿⠿⠿⠿⠿⠿⠿⠿⠿⠿
⠀⠀⠠⠠⠅⠛⠎⠀⠠⠃⠗⠁⠊⠇⠇⠑⠀⠠⠇⠁⠃⠑⠇⠑⠗⠀⠠⠠⠃⠇⠤⠼⠁⠚⠚⠚
⠀⠀⠫⠒⠐⠳⠒⠋⠹⠀⠟⠴⠐⠳⠀⠑⠐⠯⠑⠒⠀⠰⠠⠠⠃⠇⠤⠼⠁⠚⠚⠚
The first line Software version number “version *” (English)
The second line Test pattern
The third line “KGS Braille Labeler BL-1000” (English)
The fourth line “KGS Braille Labeler BL-1000” (Japanese)
Procedure of test print
1. After connect AC adaptor with BL-1000 LINK, turn on the power supply
switch while pushing both Set Key
and Reset Key.
A Braille tape isn’t ready, if slightly
long beep sound at three times after
mechanical movement sounds
shortly.
2. Try to set a Braille tape again, while referring to the procedure as shown as
above, if slightly long beep sound at three times.
Push Set key and start to print.
Try to take the same procedure from item (1), if
print doesn’t start.
A Braille tape moves to the tape position to be cut
after the print of one line ends, and the beep starts
to sound at invervals of 2 seconds.