Instruction Manual

Braille Labeler BL-1000 LINK

2. How to make braille tape

This chapter mentions procedures to print braille dots on tape after connect BL-

1000 LINK to PC.

If the necessary software’s haven’t been installed into PC, please refer to the

chapter of [1.8 Preparation for PC before connect BL-1000 LINK with it] and start

to install.

2.1 Connecting BL-1000 LINK with PC

Connect AC Adaptor to BL-1000 LINK, turn on the power supply switch.

Then the head of braille tape is automatically at the starting point to print dots.

Set new braille tape, if it is exhausted.

Connect BL-1000 LINK with PC, according to the following instructions.

2.1.1 USB Connection

Procedures

1. Boot PC.

2. Connect BL-1000 LINK with PC by a USB cable.

2.1.2 Bluetooth Connection

Procedures

1. Pair BL-1000 LINK with PC.

Press [Windows] key and [X] key at the same time,

select “Settings” from the menu.

2. Select “Devices” on “Windows Settings” screen.