Instruction Manual
Braille Labeler BL-1000 LINK
25
3. Following window is displayed, if USB port can’t be retrieved.
When this window is displayed, choose communication port, which connect BL-1000 LINK,
and click [Next].
Attention
Once choose communication port, “Braille Labeler Port Selection” window isn’t displayed
from next time at the print.
Boot Braille Labeler Utility again, in the case of change the communication port on the
way.
4. Followig window is displayed.
Check “Cut every line” in the check box, when cut a braille tape after printed dots by a
scissors of BL-1000 LINK.
Take off check “Cut every line” in the check box, when continue to print dots and cut
braille tape of printed dots by scissors by yourself later.
Choose quantity of how many pieces of a braille tapes to be printed dots, click [Start], and
then start to print dots.