Instruction Manual

Braille Labeler BL-1000 LINK
27
7. Push Set key, and the following print starts. Procedure 6 and 7 as shown above
repeats after it.
A black width of top and bottom has different one, after printed. Narrow one of
blank width shows the upper part. (A<B)
(Attention)
After print ends, and if you push Cut key before a braille tape will move to the
tape position to be cut, the last printed dots would have been cut.
Please make sure that you’ll push Cut key after the beep starts to sound.
If the last printed dots are remained on the tape position to be printed next, please
push Set key for a little bit long, then let a braille tape move to the tape position
to be cut, push Cut key and remove the printed dots tape.