Instruction Manual

Braille Labeler BL-1000 LINK
5
1.2 Precautions on use
To preserve and maintain the conditions of the BL-1000 LINK, please take note
of the following precautions listed below.
 Do not drop, neither strike, nor apply strong shock to BL-1000 LINK,
since it is a precision instrument.
 Avoid spilling water, tea, dryings and etc, into BL-1000 LINK.
 Do not keep or stock BL-1000 LINK and braille tape for BL-1000 LINK
exclusive use in the place where the direct rays of the sun pours and or
in the place where it becomes high temperature like in the car, close to
window or stove or so on.
 Do not disassemble BL-1000 LINK. By disassembling the BL-1000 LINK,
no guarantee is made.
 Use an attached AC adaptor only for BL-1000 LINK exclusive use. Please
do not use other kinds of AC adaptor. It has to be so danger if you’ll use
other kinds of adaptors.
 Be sure to earth the AC cord to an earthed outlet. Also, plug it into an
easily accessible outlet near the equipment and unplug it immediately if
there is smoke or a strange odor.
 Use a braille tape only for BL-1000 LINK exclusive use. It will be
malfunction and or cause to break BL-1000 LINK like stuffed tapes and
or bad quality of embossed dots, if you’ll use other kinds of tapes.
 Use BL-1000 LINK after closing the lid and or cover to be opened and
closed to avoid gathering dust.
 Please make sure to fix the cover of both print and braille tape to each
portion to be set.
 Do not the following actions to prevent clogged tape inside BL-1000
LINK.
 Do not cut the tape on the way of to print dot, to send and or rewind tape.
 Do not print at less remains of tape.
 Please confirm the braille tape position to be fixed inside the tape guide
rail, which is located in the right side of cover for dots print, before print.
 Please change the braille tape at less remains of tape.
 If pieces of the braille tape will be remained inside of BL-1000 LINK,
please open the cover for dots print and remove them by a pair of
tweezers and etc.
 Due to the properties of the roll tape, the tape may be bent or twisted
when printed continuously for a long time. To keep print quality, it is
recommended to divide it into about 50 columns and cut once.