Instruction Manual

Braille Labeler BL-1000 LINK
9
Set Key
Set Key is used to send the top of a braille tape.
Cut Key
Cut Key is used to cut a braille tape after printed dots.
If inside scissor and or Cut key does not come back to the
normal position, snag the opening in front of Cut key on
something thin and pull up.
Reset Key
Reset Key is used to reset the memory of the data which is
waiting for the print, left in buffer.
Send Key
Send Key is used to send a braille tape to the left side by
rotating a tape roller. Please try to use this key when a
braille tape clogs.
Rewind Key
Rewind Key is used to rewind a braille tape to the right
side by rotating a tape roller. Please try to use this key
when a braille tape clogs.
LED light
display
By a color of Lighting and or Off, you can confirm the
situation of BL-1000 LINK.
Cover for a
braille tape
To set a braille tape in the body, please get the cover off.
Please shut the cover at the printing dots.
LED Light display
Red lighting
It indicates “Turn On”.
Green
lighting
It indicates a braille tape is set properly in right position.
Yellow
lighting
It indicates Waiting data memory is remained in the
buffer.
Buzzer sound
Three times of
Slightly long beep
sound
It indicates a situation that a braille tape is
exhausted and or it isn’t set properly at the “Turn
ON” or pushing Set key.
Two times of
rather short beep
sound
It indicates a situation after printed dots on a braille
tape. This sound continues until printed braille tape
will be removed from a tape exit after cut. Any kind
of jobs will not be accepted without pushing Cut key.
Three times of
short beep sound
It indicates a situation that reset the buffer by
pushing Reset key. Yellow LED is also put out.