User Manual

ENGLISH

Aurora Series: Geng Started

DVR User’s Manual

Geng Started

Installing the Hard Disk Drive

Depending on the package you have purchased, the hard disk drive may be included in the full package. If it is not

pre-installed, follow the installaon instrucons on this user manual.

DO NOT install or remove the hard disk drive while the device power is turned on.

The DVR supports one 3.5” SATA hard disk drive. To install the HDD, follow the steps below.

Note:

The illustraons below show an 8-channel DVR, same procedures apply to a 4/16-channel DVR.

Step 1: Remove the cover

a. Loosen the screws in the le, right, and rear sides as shown.

b. Push back then li up the cover to remove it.

Step 2: Install HDD

Connect the data and power cables to the hard disk drive (HDD) and place the HDD on the DVR case.