User Manual

ENGLISH
Aurora Series: Conguring DVR Sengs
38
DVR User’s Manual
Record Setup
Basic
Set the audio funcon and recording
mode for each channel.
Enable: Check to enable or uncheck
to disable the record mode for a
channel.
Audio: Check to enable the audio
recording for a channel. Uncheck to
disable this opon.
Note:
This funcon requires a camera
with the audio support or an
external microphone.
Mode: Select the type of recording mode. There are two types of recording modes available: Always and Schedule.
Always: The DVR will connuously record for any period where Always mode is selected.
Note:
Make sure the space on hard disk is sucient when using constant recording.
Schedule: The recording is performed according to a pre-dened schedule. To dene the schedule. see “Schedule” on
page 39.
Copy CH/To CH: Copy the current sengs to all channels or one specic channel. Click the arrow to select an opon
and then click Copy.
Aer all sengs are complete, click Apply.
Bit rate
The bit rate secon allows you to
congure the actual amount of data
that the DVR will use to record a
video. The parameters that can be
congured is video resoluon, frame
rate, and quality sengs for each
channel.
Resoluon: The two types of record
modes are as follows: D1 (CIF/HD1/
D1); 960H (WCIF/WHD1/WD1). The
resoluons CIF, WCIF, WD1 (960H)
can be selected only to channel 5 or
higher channel.