User Manual

ENGLISH
Aurora Series: Conguring DVR Sengs
DVR User’s Manual
45
Note:
Be sure to complete the E-mail and DNS server sengs before enabling this funcon.
Alarm output: If an alarm device is connected, check the box to make the device sound the alarm when moon is
detected.
Push: Check the box to enable Push Event funcon on Mobile/Pad when the moon is detected.
Note:
To use Push Event funcon, you need to do the following:
- Enable MyKguard in DVR (see “MyKguard” on page 51).
- Congure the DVR network connecon parameters.
- Download KView QR on your smart phone/pad. If you are using an iOS portable device, you need to enable
the Push Event funcon on app too.
Alarm output duraon: Select the alarm sound duraon of the I/O alarm device.
Buzzer: Set the buzzer duraon when the moon is detected.
Pop-up screen: Select the corresponding channel will be displayed in full screen when the moon is detected.
Pre record: Set the recording period in seconds just before the moon triggers recording.
Post record: Set the recording period in seconds aer the moon triggered recording has nished.
P.T.Z: Check the box to acvate cruise of the PTZ camera on the specied channel when the moon is detected.
Click OK to save the sengs.
Sensor
Customize the sensor sengs.
Enable: Click to enable sensor alarm.
Type: Select the sensor type between
N/O (Normal Open) and N/C (Normal
Close).
Please check the documentaon of
sensors to learn the correct value to
use.
Name: Specify the sensor name.
Schedule: Set the sensor detecon
schedule. See “Sensor Schedule
Setup” on page 46.
Trigger: Congure the acons to be taken when sensor is triggered. See “Sensor Trigger Sengs” on page 46.
Copy CH/To CH: Copy the current sengs to all channels or one specic channel. Click the arrow to select an opon
and then click Copy.
Aer all sengs are complete, click Apply.