User Manual

ENGLISH
Aurora Series: Conguring DVR Sengs
DVR User’s Manual
47
Note:
Be sure to complete the E-mail and DNS server sengs before enabling this funcon.
Alarm output: If an alarm device is connected, check the box to make the device sound the sensor when triggered.
Push: Check the box to enable Push Event funcon on Mobile/Pad when the sensor is triggered.
Note:
• To use Push Event funcon, you need to do the following:
- Enable MyKguard in DVR (see “MyKguard” on page 51).
- Congure the DVR network connecon parameters.
- Download KView QR on your smart phone/pad. If you are using an iOS portable device, you need to enable
the Push Event funcon on app too.
Alarm output duraon: Select the alarm sound duraon of the alarm device.
Buzzer: Set the buzzer duraon when the sensor is triggered.
Pop-up screen: Select the corresponding channel will be displayed in full screen when the sensor is triggered.
Pre record: Set the recording period in seconds just before the alarm sensor input (before the alarm sensor triggers
the recording).
Post record: Set the recording period in seconds aer the alarm sensor input (aer the alarm sensor triggered
recording has nished).
P.T.Z: Check the box to acvate cruise of the PTZ camera on the specied channel when the sensor is triggered.
Click OK to save the sengs.
Video Loss
Video loss is regarded as a potenal
alarm event, and is considered to
occur any me that the DVR does not
receive an acve signal on any of its
inputs.
The default behavior of the DVR,
when a channel has no incoming
video signal, is simply to display
“Video Loss” in light blue text on a
black background over the associated
channel. If you’re not using all the
inputs on your DVR, then some
channels will be in constant Video
Loss state. Make sure that you don’t
Enable a video loss acon for these
channels.
Enable: Click to acvate video loss monitoring funcon.
Trigger: Congure the acons to be taken when the DVR does not receive any video input signal from the connected
camera(s). The sengs conguraon is similar to Sensor Trigger. See “Sensor Trigger Sengs” on page 47.
Copy CH/To CH: Copy the current sengs to all channels or one specic channel. Click the arrow to select an opon
and then click Copy.
Aer all sengs are complete, click Apply.