User Manual

ENGLISH
Aurora Series: Conguring DVR Sengs
48
DVR User’s Manual
Others
Customize the event(s) alarm sengs.
Disk error: Select Enable to trigger the
alarm if the DVR has trouble to access
or detect the hard disk drive.
Disk full: Select Enable to trigger the
alarm when the hard disk drive is full.
IP address conict: Select Enable to
trigger the alarm if the DVR has detect
another device on the same network
using the same IP address.
Trigger: Congure the acons to be
taken when the event type occurs. See
“Event Trigger Sengs” on page 49.
Aer all sengs are complete, click Apply.
• Event Trigger Sengs
In Trigger, click Sengs to congure
the acons to be taken when the
event type occurs.
Send E-MAIL: Check to enable e-mail
alarm nocaon. If the funcon is
enabled, the system will send the
alarm messages to the specied
e-mail address.
Note:
Be sure to complete the E-mail and
DNS server sengs before enabling
this funcon.
Alarm output: If an alarm device is connected, check the box to make the device sound the alarm when triggered.
Push: Check the box to enable Push Event funcon on Mobile/Pad when the event type occurs.
Note:
• To use Push Event funcon, you need to do the following:
- Enable MyKguard in DVR (see “MyKguard” on page 51).
- Congure the DVR network connecon parameters.
- Download KView QR on your smart phone/pad. If you are using an iOS portable device, you need to enable
the Push Event funcon on app too.
Alarm output duraon: Select the alarm sound duraon of the alarm device.
Buzzer: Set the buzzer duraon when the event type occurs.
P.T.Z: Check the box to acvate cruise of the PTZ camera on the specied channel when the event type occurs.
Click OK to save the sengs.