User Manual

Table Of Contents
ENGLISH
Chapter 5: KGUARD Web Client
90
DVR Users Manual
5.5.4 Seng the Network Conguraon
You can use the Network menu to setup how the DVR connects to the network. It provides 3 network connecon
opons: Stac IP, DHCP, and PPPoE.
Note:
Consult your network administrator or the Internet Service Provider (ISP) to determine the type of connecon you are
using and the required parameters to complete the setup.
Network Sengs
To congure the network sengs, do the following:
1 On the Main Menu, click Remote Seng.
2 On the le panel, click Network > Network. The Network screen appears.
DCHP: With Dynamic Host Conguraon Protocol
(DHCP) service, your router will automacally assign
an IP address to your computer connected to the
network.
PPPoE: The Point-to-Point Protocol over Ethernet
(PPPoE) is a network protocol for encapsulang
Point-to-Point Protocol (PPP) frames inside Ethernet
frames. This network protocol allows the device to
be directly connected using a DSL modem.
Stac IP: This network protocol allows you to
congure the network interface using a xed IP
address.
3 Specify the Client Port and HTTP Port numbers.
Client Port: Specify the port number that the device will use to send DVR command and video stream.
HTTP Port: Specify the port number that you will use to log in to the device.
Note:
Obtain these informaon from your network administrator or your Internet Service Provider (ISP).