User Manual
Table Of Contents
- About this Manual
- Chapter 1: Product Overview
- Chapter 2: Installation
- Chapter 3: Getting Started
- Chapter 4: Using the DVR
- Chapter 5: KGUARD Web Client
- 5.1 Login
- 5.2 The Interface
- 5.3 Live Viewing
- 5.4 Searching and Playing Recorded Videos
- 5.5 Remote Settings
- 5.6 Local Settings
- Chapter 6: Using KView Series Software
- Chapter 7: Troubleshooting & FAQ
- Appendix: Specifications
ENGLISH
Chapter 5: KGUARD Web Client
DVR User’s Manual
97
7 Modify the necessary sengs:
Menu item Descripon
Sensivity Select the moon detecon sensivity rate. Opons are : 1~8, wherein “8” is the
most sensive and “1” is the least sensive.
Buzzer Set the buzzer duraon when moon is detected
(O/10 S/20 S/40 S/60 S).
To disable buzzer, select O.
Full Screen Check the box to enable this funcon. If this funcon is enabled and the alarm is
triggered, the corresponding channel will be displayed in full screen.
Enable Record
Check the box to enable recording when the moon is detected.
Post Recording
Select the post recording duraon. Enable Record must be checked to use this
funcon.
Record Channel
Check the box of Enable Record and then select the channels to record when the
moon is detected.
Show Message
Check the box to display a message on screen when the alarm is triggered.
Send Email Check to enable email alarm nocaon. If the funcon is enabled, the system will
send the alarm images to the specied email address.
8 To save the sengs, click Apply at the boom of the screen.
When moon detecon is enabled on a channel, the moon detecon icon
M
appears on the channel screen shown
on the monitor connected to the DVR.
Seng the Alarm Nocaon (16-Channel only)
1 On the Main Menu, click Remote Seng.
2 On the le panel, click Alarm > Alarm. The Alarm screen appears.
3 Modify the necessary sengs:
Menu item Descripon
Alarm In
Select the channel that will trigger the alarm.
Alarm Type
Select the alarm type: NO (Normal-Open), NC (Normal-Close), or OFF.
Buzzer Set the buzzer duraon when alarm is triggered
(O/10 S/20 S/40 S/60 S).
To disable the buzzer, select O.
Dwell Time Select the alarm sound duraon of the I/O alarm device
(10S/20S/40S/60S) then check
to apply the seng to each alarm type.
Show Message
Check the box to display a message on screen when the alarm is triggered.