User Manual
Table Of Contents
- About this Manual
- Chapter 1: Product Overview
- Chapter 2: Installation
- Chapter 3: Getting Started
- Chapter 4: Using the DVR
- Chapter 5: KGUARD Web Client
- 5.1 Login
- 5.2 The Interface
- 5.3 Live Viewing
- 5.4 Searching and Playing Recorded Videos
- 5.5 Remote Settings
- 5.6 Local Settings
- Chapter 6: Using KView Series Software
- Chapter 7: Troubleshooting & FAQ
- Appendix: Specifications
ENGLISH
Chapter 5: KGUARD Web Client
98
DVR User’s Manual
Send Email Check to enable email alarm nocaon. If the funcon is enabled, the system will
send the alarm images to the specied email address. See “4.4.3 Email Sengs” on
page 54.
Full Screen Check the box to enable this funcon. If this funcon is enabled and the alarm is
triggered, the corresponding channel will be displayed in full screen. Select the screen
display duraon (1 S/3 S/5 S/7 S/10 S)
Alarm Out
If an alarm device is connected, check the box to make the device sound the alarm
when triggered.
Enable Record
Check the box to enable recording when the alarm is triggered.
Post Recording Select the post-recording duraon.
Enable Record
must be checked to use this
funcon.
Record Channel
Check the box of Enable Record and then select the channels to record when the alarm
is triggered.
4 Aer all sengs are complete, click Save.
« TIP »
• To apply the same recording sengs to other channels, click Copy. See “Copying Sengs To Other Channels”
on page 85.
• To cancel any modicaons and retain the exisng sengs, click Refresh.