Owner manual
Table Of Contents
- About this Manual
- Chapter 1: Product Overview
- Chapter 2: Installation
- Chapter 3: Getting Started
- Chapter 4: Using the DVR
- Chapter 5: KGuard Web Client
- 5.1 Login
- 5.2 The Interface
- 5.3 Live Viewing
- 5.4 Searching and Playing Recorded Videos
- 5.5 Remote Settings
- 5.6 Local Settings
- Chapter 6: Using KView Series Software
- Chapter 7: Troubleshooting & FAQ
- Appendix: Specifications
ENGLISH
Chapter 5: KGuard Web Client
DVR User’s Manual
57
Chapter 5: KGuard Web Client
Use KGuard Web Client to remotely access the DVR at anyme.
To access KGuard Web Client you must ensure the following requirements are met:
• The Network sengs of the DVR is properly congured. See “4.2 Seng the Network” on page 33.
• Your computer has a web browser, such as Internet Explorer, installed.
5.1 Login
KGuard Web Client allows up to 3 simultaneous access. However, only one administrator account is allowed per access.
1 Open your computer web browser and enter the DVR IP address or domain name in the URL box.
For example, see illustraon below:
Don’t know the IP Address of your DVR?
The IP address of the DVR vary depending on the network sengs you congured in NETWORK menu (see “4.2
Seng the Network” on page 33).
• If your network type is DHCP, ask your network administrator for the IP address assigned to the DVR.
• If your network type is PPPoE, ask your Internet Service Provider (ISP) for the IP address assigned to the DVR.
• If your network type is Stac IP, check the IP address you congured for IP ADDR in NETWORK menu.
• If the DVR is connected to a DDNS, check the Domain Name that you congured when you created the DDNS
account and type the domain name in the URL box.
2 Enter the User Name and Password.
Select language
here.
Note:
The default administrator User Name is “admin” and the password is empty. To change the password, see
“Changing the Password” on page 49.
3 Click Login.