User Manual

ENGLISH
Chapter 5: KGUARD Web Client
DVR User’s Manual
69
7 To disable moon detecon on an area, click a marked block and then drag the mouse to highlight the scope that
you want to unmark (area turns white). Or, click Clear to unmark all areas and then select a new area to mark for
moon detecon.
8 To save the sengs, click Apply at the boom of the screen.
When moon detecon is enabled on a channel, the moon detecon icon
M
appears on the channel screen shown
on the monitor connected to the DVR.
« TIP »
• To revert to default sengs, click Default at the boom of the screen.
• To cancel any modicaons or close the screen, click .
Alarm Setup
1 On the Main Menu, click SETUP.
2 On the le panel, click Alarm.
3 On the Alarm submenu, select Other.
4 Modify the necessary sengs.
Menu item Descripon
Video Loss Check to trigger the alarm when the camera signal is not detected.
HDD Space Check to trigger the alarm when there is not enough hard disk space.
HDD Loss Check to trigger the alarm when the hard disk drive is not detected.
Buzzer Set the buzzer duraon when moon is detected (OFF/10s/20s/40s/60s).
Post Rec Select the post recording me aer the alarm ends.
(5s/10s/15s/20s/30s/1Min/2Min/5Min).
5 Aer all sengs are complete, click Apply at the boom of the screen.
« TIP »
• To revert to default sengs, click Default at the boom of the screen.
• To cancel any modicaons or close the screen, click .