User Manual

ENGLISH
Chapter 5: KGUARD Web Client
70
DVR User’s Manual
5.5.4 PTZ Sengs
When a PTZ camera is installed, use the PTZ menu to customize its sengs.
1 On the Main Menu, click SETUP.
2 On the le panel, click PTZ. The PTZ Setup screen appears.
3 On the PTZ submenu, select the channel where the PTZ camera is installed.
4 Set the PTZ control Protocol, Baud Rate, Data Bit, Stop Bits, and Address.
Note:
Check the PTZ camera specicaons for the correct sengs.
5 Set Auto Cruise to Enable or Disable, and select a Verify opon (None/Odd/Even/Mark/Space).
6 To save, click Apply at the boom of the screen.
« TIP »
• To revert to default sengs, click Default at the boom of the screen.
• To cancel any modicaons or close the screen, click .