User`s manual

WI-FI Network Camera User’s Manual
11
Making Connections
Wired Router/Modem
If you are using a wired router/modem, conrm the type of internet connecon you are using and the related network
connecon parameters with your Internet Service Provider (ISP), to complete the setup.
Dynamic Host Conguraon Protocol (DHCP): Select this connecon if your camera is connected to a router and DHCP
is enabled.
Stac IP (Stac Address): Select this connecon if your camera is directly connected to a DSL modem and your ISP has
supplied you with a predened IP for your Internet connecon.
Point-to-Point Protocol over Ethernet (PPPoE): Select this connecon if your camera is directly connected to the DSL
modem, and your ISP has supplied you with an authencaon username and password to the Internet.
DHCP
To establish a connecon from the camera to the wired router using DHCP, perform the following:
1. Connect the camera to the power socket, using the power adapter.
2. Connect one end of the RJ45 cable (supplied) to the camera and the other end to the wired router.
DC IN1234WPS RESET
Internet
3. Make sure your camera and computer are connected to the same router.
DC IN1234WPS RESET
Internet