User`s manual

WI-FI Network Camera User’s Manual

Web Client

Alarm Duraon: Set the external alarm output duraon.

Lose SD-Card Alarm: Select on to automacally trigger the alarm if the Camera cannot detect the memory card.

Alarm Input1: Check the Enable box to enable alarm input. Select the alarm type in Mode.

NOTE: N.O. = Normal open; N.C. = Normal close.

Linkage With Alarm: Check this box to acvate the following acon when the alarm is triggered.

• Alarm Output: Check this opon to enable alarm output.

• SD-Card Record: Check this opon to save the recorded videos directly into the SD card. See

“SD Card” on page 38.

• Send E-mail: Check this opon to send a nocaon e-mail. See “E-mail(SMTP)” on page 36.

• FTP Upload: Check this opon to upload the snapshots to the FTP server. See “FTP” on page

37.

Network

Congure how the Camera connects to the network. This Camera provides three network connecon opons: Stac IP

(Stac Address), PPPoE, and DHCP (Dynamic Address).

Network Type: Select the type of network connecon you are using.

• Stac Address: Select this connecon if your camera is directly connected to a DSL modem and your ISP has

supplied you with a predened IP for your Internet connecon.

• PPPoE: Select this connecon if your camera is directly connected to the DSL modem, and your ISP has supplied

you with an authencaon username and password to the Internet.