User`s manual

WI-FI Network Camera User’s Manual
31
Web Client
• DHCP: Select this connecon if your camera is connected to a router and DHCP is enabled.
Media Port: Enter the port number that the device will use to send Camera command and video stream.
Web Port: Enter the port number that you will use to log in to the device via the web.
Phone Port: Enter the monitoring port of your mobile device. The port range is between 1024 to 65535.
NOTE: The Phone Port specied here must be the same port on your mobile device.
RTSP Port: Enter the RTSP port specied in the device.
IP Address: Enter the stac IP address.
Subnet Mask: Enter the subnetwork IP address.
Gateway: Enter the gateway IP addresss.
Enable PPPoE: Select open to use PPPoE network connecon.
PPPoE User: Enter the user name that your ISP has supplied.
PPPoE Password: Enter the password that your ISP has supplied.
PPPoE IP Address: Enter the IP address that your ISP has supplied.
DNS Server: Enter the DNS server address.
MAC Address: View the Camera MAC address.
NOTE:
• Obtain these informaon from your network administrator or your Internet Service Provider (ISP).
• If you cannot use the either of the two default media.web ports, 80 or 38401, the specied port may be occupied
by other programs or it is being blocked by your service provider. Enter other port number. In this case, you need
to add the port number aer the IP address. For example, if you set the Web Port as 85, you need to enter the IP
address as “192.168.3.103:85”.