User`s manual

WI-FI Network Camera User’s Manual

Network Conguraon

Procedures of Network Conguraon depend on the type of Router/Modem you are using.

For Wireless router, check if your wireless router supports WPS funcon.

For Wired router/modem, conrm which type of internet connecon (DHCP, Stac IP and PPPoE) you are using with

your Internet Service Provider (ISP) to complete the setup.

Wireless Router

If you are using a wireless router, check if your router supports WPS funcon before wireless setup.

Wireless Router With WPS Funcon

If your wireless router supports WPS funcon, perform the following to establish a connecon from the camera to the

wireless router. Make sure the WPS funcon on router is acvated rst.

1. Connect the camera to the power socket, using the power adapter.

2. Using a Pin tool, press and hold down the WPS/Reset buon for 2 seconds. The camera’s status LED (red)

starts blinking.

3. On your wireless router, press the WPS funcon key for a minute, to start WPS pairing.

IMPORTANT: For the WPS pairing process, you must press the WPS funcon within 1 minute aer

pressing the WPS/Reset buon in Step 2. However, the step may vary, depending on the wireless router’s

conguraon.

DC IN123

PS RESET

Internet

WPS

Making Connection