Congratulations You are one step closer to experiencing Sirius Sat elite Radio. Sirius will revolutionize your in-home or vehicle entertainment with: 100 streams of original programming, including 60 streams of completely commercial-free music — guaranteed.
Cautions and Warnings 1. Do rot install the Shuttle in a position that hinders your view through the windshield, or obstructs view ing of the dashboard indicators and displays. 2, Do not install the unit where it may obstruct the operation or deployment of safety devices, such as airbags, eto. 3. Do not allow operation of the unit to detract from safe driving practices; remember that you are responsible as the vehicle operator to adheres lo ail safe driving and traffic regulations. 4.
Contents SIR-CK and SIR-CK Install Manual Base Audio Cable PIN 1286813 P/N 136G3484 PINTI2B3293 Antenna Cradle CK1 PIN 18603471 P/N 118C1126 Cradle CK2 PIN 13603472 ) 1p3. DC Power Adapter PIN112B3203 1 pe. Ae Phillips Machine Resew (M4 x BMW) © «i Split Lock Washer, M4 4 pos 4 pes. 3/4” WX longing Flat Washer, M4. Double Sided Tape © LLL) 1po 4 pos. OPTIONAL Alcohol Swab FM Switching Box Says PIN 112C3159 {6 Meter} [ 1 pe. 1pe.
Installation/Wiring Precautions 1. To prevent a short-circuit, be sure to turn off the ignition and remove the negative battery cable prior to installation. Connect power wires last. . Do not install the unit is the locations exposed to direct sunlight or, In areas subject to extreme temperatures, . Incorrect installation may cause damage to the system. Mount the unit firmly in place, using the supplied hardware. . Ba careful not to damage the vehicle wiring . Be sure to use the supplied screws and washers.
Interconnect Diagram Interconnect Diagram FM Option FM FREQUENCY SELECTION SWITCH AUB SELECT 1 OF 4 AVAILABLE FREQUENCIES f— pre AND SET YOUR EXISTING CAR RADIO TO VESICLE Anion SHUTTLE CRADLE THE SAME FREQUENCY Ft RADII ANTENNA Ki OR Ck2 SHUTTLE CRADLE NY Low Cit ONLY AUXILIARY AUDIO INPUT OF RADII OR BC POWER | ENTERTAINMENT SYSTEM Fl ADAPTER , TO VEHICLE \ oo Toehold +12 ¥DC POWER | OVERPOWER RECEPTACLE s ! NOTE: ' 1. THE FI TRANSMITTER OPTION MUST ' BE SET THE SHUTTLE v USER MENU.
do. The cradle contains two mounting plates, one on the rear and ane on the bottom. After deciding which configuration io use, loosen and remove two flat-head screws souring the plate to the cradle and remove the plate. Save the two screws for reassembly. CAUTION: Do not install the mounting base on a leather or fabric surface, or in a position that could impair your vision, block air bag(s} or obstruct vehicle dashboard control and/or radio Cassette operational displays.
% insert the end of the ball strut into the keyed opening on the cradle mounting plate, and secure the plate to the ball strut using the flat washer, lock washer and flat-head screw through the back of the plate, 3. Reattach the mounting plate assembly to the rear or bottom of the cradle assembly, as desired, using the two flat-head screws removed previously.
NOTE: Allow a 72-hour period for the adhesive backing to cure completely. k Using the star nut, attach the cradle assembly to the base threaded socket; do not over tighten the star nut. 3. Installing the Cradle Using Doubt-Sided Tape You can mount the cardie directly to your dashboard or other flat surface without using the cradle mount in the kit, To do this, do not reeve either of the mounting plate assemblies from the cradle. a. Turnover the 3/4” x 3” double-sided tape from the supplied kit, b.
TOP RETAINING 18-PIN SYSTEM CLP CONNECTOR SAT, (MAIN) CONNECTOR TERR CONNECTOR BOTTOM BOTTOM LEFT SLIDE BIGHT cup ‘6. Sirius Program Listening Options The Shuttle and Cradle provide an audio output signal in three manners; 1. When using CK1 or CK2 cardie, the audio signal can be routed through an audio cable which is applied to the auxiliary inputs of a radio or entertainment system. 2. When using the CK1 cradle, the audio signal can be transmitted to a car radio on one of four delectable Frequencies.
7. Mounting the Vehicle Antenna The antenna should be placed un a relatively flat surface on the vehicle exterior, preferably on the roof {high point} or on the trunk {convertible}, To mount the antenna: a. Plug the antenna into the SAT. (MAIN) connector on the back of the cradle. b. Place the antenna at the preferred location on the roof or trunk surface. if the vehicle is equipped with a roof or trunk rack, the antenna may have to be mounted off-center on the surface.
. Plan the routing of the antenna cable to the Shuttle RF input. Make sure you avoid any obstructions that could crimp, kink or twist the cable; use protective grommets wherever rough openings are encountered, Route the cable from the antenna position to the interior of the vehicle, working the cable under the rear window molding; make adjustments and take up slack whenever ‘necessary. . At the lowest point of the rear window, route the cable into the trunk, taking advantage of existing cable conduits.
Plug the antenna cable into the SAT (MAIN connector on the back of the cradle; then plug the cigarette lighter adapter into the lighter receptacle. The integral power LED of the power button will light red. You are now ready to enjoy Sirius programming within your vehicle. CAUTION: You could drain the vehicle battery if : the cigarette lighter adapter remains plugged in after the ignition is turned off. Unplug the adapter to prevent this possibility.
AUDIOYOX™ 12 MONTH LIMITED WARRANTY CORPORATION AUDIOVISUAL CORPORATION the Company) warrants to the origins! retail purchaser of this product that should this product or any part therapy, under enormous and conditions, be proven defective in material of workmanship within 1 2 mantes from the date of original purchase, Such defects} will be repaired of replaced with new or reconditioned product (at ihe Company's option) without charge for parts and pallor labor.