Owner Manual

ManualsBrandsKIBI ManualsBathroom Remodel & Bathroom FixturesMirage Single Hole Bathroom Faucet

Problem Cause Action

Low flow

Aerator(4) or fliter(8) may be

clogged

Unscrew aerator to check rubber packing or replace

aerator.

(Note: some models require wrench to remove aerator.)

Faucet leaks from

under handle

Bonnet(2) nut has come loose

or cartridge(3) needs to be

reseated

Remove handle and cap. Using a wrench, ensure bonnet

nut is tight.

Water will not shut off

completely.

Dirty or worn out plastic washer

in the cartridge.

Adjust or replace cartridge.

WARNING: Failure to securely tighten bonnet nut with a

wrench could result in water damage.

LIMITED LIFETIME WARRANTY

KIBI provides its customers with an extensive warranty as a result of our excellent workmanship and high quality

components used in our products.

Mechanical warranty: A limited lifetime warranty is provided on all mechanical parts to be free from manufacturing

defects in materials and workmanship under normal use for as long as the original purchaser owns their home.

Finish warranty: A 5-year warranty is provided on all KIBI faucet finishes to the original purchaser against manu-

facturing defects in materials and workmanship.

At its sole discretion, KIBI will repair or replace any part or finish that proves to be defective in material and/or

workmanship under normal installation, use and service.

This warranty is extended to the original consumer owner, but does not cover installation or any other labor

charges. In no event shall KIBI be liable for any incidental, consequential or special damages, installation cost,

labor, travel time, freight costs incurred, lost profits, or contingent liabilities. KIBI makes no representation that its

products comply with any or all local building or plumbing codes. It is the consumer’s responsibility to determine

local code compliance.

TROUBLE SHOOTING

CLEAN AERATOR AND FLITER

CLEANING AND CARE

Clean the faucet often with a soft cloth to keep it looking like new. For heavy cleaning you can use mild liquid deter-

gents or non-abrasive liquid polisher. Rinse with water and dry with a soft cloth. Avoid abrasive cleaners, steel wool

and harsh chemicals as these will dull the finish and void your warranty.

If you’ve followed the instructions carefully and your faucet still does not work properly, take these corrective steps.

Installation Guide

www.kibiusa.com

Mirage

KBF1001

Summary of content (2 pages)

PAGE 1
TROUBLE SHOOTING If you’ve followed the instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action Low flow Aerator(4) or fliter(8) may be clogged Unscrew aerator to check rubber packing or replace aerator. (Note: some models require wrench to remove aerator.) Faucet leaks from under handle Bonnet(2) nut has come loose or cartridge(3) needs to be reseated Remove handle and cap. Using a wrench, ensure bonnet nut is tight.
PAGE 2
DIMENSIONS INSTALLATION 1 2 Shut off water suppliers. Remove the old faucet, clean the mounting surface. Note: For first time install, flush the pipes first by open the angel valve to run 60s. Remove the mounting hardware from the mounting pipe. 3 4 Put the rubber O-ring into the bottom gap of faucets then Insert faucet into faucet hole. From below the sink, Slide rubber washer, metal washer and mounting bracket onto the thread shank.