Installation Guide

INSTALLATION INSTRUCTIONS
4
12) Optional Photo control Installations:
A) Make sure power is o and transformer is NOT plugged into an electrical outlet. NOTE: No splice is
required, transformer is equipped with jumper connector.
B) Unscrew the photocell connector dust cap from the transformer and plug the photocell bi-pin
connector into the mating socket. Screw the bi-pin cap onto the socket to provide a water tight connection.
Note that the bi-pin connector is polarized and can be inserted into the socket only one way.
C) Avoid pointing the sensor at nighttime light sources such as windows, porch lights, and street lights.
Placing the sensor in areas receiving less sunlight at dusk (east side of house, behind trees and bushes, under a
deck) will have the transformer come on earlier in the evening. Mounting the photocell in brighter locations
will have the transformer come on when it has become darker out.
D) Mount the photocell bracket on a wall or other solid surface with the screws provided.
Snap the sensor into the bracket. Route or coil the excess wire to protect it from lawn mowers, trimmers, etc..
The photo eye operation can be tested by turning the transformer mode to TEST.
13) Plug power supply cord into standard 115/120 volt receptacle. NOTE: The power supply cord must be
plugged into a weather tight receptacle equipped with a Ground Fault Interrupter (GFCI).
*Placing the sensor in areas receiving less sunlight at dusk will have the transformer come on earlier. Mount-
ing the photocell in brighter locations will have the transformer come on when it has become darker out.
Adjust the location and position of the photocell until the transformer turns on at the desired level.
Landscape Lighting Warranty and Limitations
Subject to Kichler’s General Warranty and Limitations and aside from the exceptions noted below, Kichler
warrants that Landscape Lighting Products whose model numbers begin with the numbers “28” will be free
from defects in material and workmanship for seven (7) years. The exceptions are:
• Low voltage landscape lighting aluminum housings and the product exterior nishes on them are
warranted for ve (5) years.
• Electronic power supplies, excluding timers and photocells, are warranted for ten (10) years.
• OEM LED Light Bulbs are warranted for ve (5) years or 25,000 hours, whichever comes rst.
• Non-LED Light bulbs carry no warranty.
• Non-Kichler branded LED bulbs supplied by, but not manufactured by Kichler carry no warranty other
than manufacturer’s warranty.
Certain acid-loving plants such as arborvitae, pine trees, and others must not be exposed to light of any kind
for more than 18 hours a day as these plants need time to sleep and allow photosynthesis to naturally occur.
As a result, Kichler warranties do not cover plants that die or burn because of continuous light shined on them.
This is not a defect but the inherent nature of such plants.
Substituting another manufacturer’s product and/or components will render the warranty completely void.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM
STATE TO STATE. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR
THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATIONS
OR EXCLUSIONS MAY NOT APPLY TO YOU.
THE FOREGOING WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THOSE
OF MERCHANTABILITY, FITNESS FOR ANY PARTICULAR PURPOSE OR INFRINGEMENT. ORIGINAL PURCHASER
SHALL IN NO EVENT BE ENTITLED TO, AND KICHLER LIGHTING SHALL NOT BE LIABLE FOR, INDIRECT, SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE, INCLUDING BUT NOT LIMITED TO LOSS OF
PROFIT, PROMOTIONAL AND/OR MANUFACTURING EXPENSES, OVERHEAD, INJURY TO REPUTATION AND/OR
LOSS OF CUSTOMERS.