Installation Guide

Rev. 10-26-16
Kichler® is a registered trademark of
The L.D. Kichler Co. All Rights Reserved
Printed in China
OPERATION
6
5
Setting the TIME ON/OFF
6
Using the TEST function
7
Power outage
8
Display Auto Shut-down
9
Restoring the Factory
Settings
This setting allows you to control the time the lights turn
on and when they will go off.
a) Press MENU until the TIME ON/OFF LED indicator is lit
and press ENTER. The digit display shows “ON” and
press ENTER or wait 3 sec.
b) When the AM and PM LED begin to flash, press the UP
or DOWN arrow button to select AM or PM and press
ENTER.
c) When the hour begins to flash, press the UP or DOWN
arrow to desired hour and press ENTER.
d) When the minute begins to flash, press the UP or DOWN
arrow to desired minute and press ENTER.
e) The display shows “OFF” indicating that you can now set
the OFF time press ENTER or wait 3 sec.
f) When AM and PM begins to flash, press the UP or DOWN
arrow button to select AM or PM and press ENTER.
g) When the hour begins to flash, press the UP or DOWN
arrow to desired hour and press ENTER.
h) When the minute begins to flash, press the UP or DOWN
arrow to desired minute and press ENTER.
In the event of a power outage the transformer functions
may need to be reset.
To restore the transformer to its original factory settings,
press and hold the OK button for 3 seconds. The
display shows 88:88 and resets to 12:00 after 1 second
to indicate the transformer is now restored to factory
settings.
This setting allows you to test your landscape lighting
after installation.
Press MENU until the TEST LED indicator is lit and
press ENTER.
The time of PHOTO EYE feeling the external light
signal: the lights will turn on at dusk and off at dawn
within 0.5 seconds.
NOTE: When using the TEST function during daylight
hours with the photo eye installed on the transformer, be
sure to completely cover the PHOTO EYE for the lights to
turn on. The photo eye needs to sense darkness in order
to function, even in TEST mode .
NOTE: If you do not press "ENTER", the transformer
defaults enter into the presently-set function within 10
seconds. In other modes outside of TEST, the transformer
defaults enter into the presently -set function within 30
seconds.
In TEST mode, the display and LED indicator lights on
the transformer turn off after approximately 10 seconds
of idle time. In all other modes, this auto shutdown
occurs after approximately 120 seconds. Press any
button to turn on the transformer display.