Installation Guide

ASSEMBLY INSTRUCTIONS
6
8. Position threaded nipple (C) in mounting bracket
(B) so that, when mounted:
• The threaded nipple (C) will protrude a
minimum of ¼ inch beyond the raised center
portion of the bracket (B).
• The threaded nipple (C) height should be
positioned so that ½ the exterior threads of
the screw collar loop (I) will extend past the
canopy (A), when it is mounted.
9. Once the proper position of the threaded nipple
(C) and bracket (B) has been determined,
secure with 3 hex nuts (D) as follows:
• Screw 1st hex nut (D) onto the threaded
nipple (C) and tighten against the raised
portion of the bracket (B).
• Screw 2nd hex nut (D) onto the threaded
nipple (C) and tighten against the flat portion
of the mounting bracket (B).
• Screw the third hex nut (D) onto threaded
nipple (C) and tighten against the screw
collar loop (I).
9
¼ Inch
D
C
I
B
8
B
A
¼ Inch
I
C
7. Raise decorative cap (U) over lower threaded
pipe (Q) and secure in place with finial (V).
V
U
Q
7