Installation Guide

1) TURN OFF POWER.
IMPORTANT: Before you start, NEVER attempt any work
without shutting off the electricity until the work is done.
a) Go to the main fuse, or circuit breaker, box in your
home. Place the main power switch in the “OFF”
position.
b) Unscrew the fuse(s), or switch “OFF” the circuit breaker
switch(s), that control the power to the fixture or room
that you are working on.
c) Place the wall switch in the “OFF” position. If the fixture
to be replaced has a switch or pull chain, place those in
the “OFF” position.
2) Assemble mounting bracket to mounting surface using hard
ware suitable for material of mounting surface.
3) Connect fixture ground wire to outlet box ground wire with
wire connector (not provided). Never connect ground wire to
black or white power supply wires.
4) Make wire connection (connectors not provided). Reference
chart below for correct connections and wire accordingly.
5) Push fixture to wall allowing threaded pipes to pass through
holes in canopy. Care should be taken to insure that wires
are completely inside canopy.
6) Thread threaded caps onto threaded pipe. Tighten threaded
caps to secure fixture to wall.
7) Insert recommended bulbs.
8) Carefully lower glass down into cage of fixture. Pass hole in
glass over sockets. Set glass down into cup on fixture.
9) Set roof down on top of cage.
10) Thread screws down into holes in roof and into cage.
Tighten screws to secure roof to cage.
INSTRUCTIONS FOR MOUNTING FIXTURE OUTDOORS AND/
OR IN WET LOCATION.
11) Mounting surface should be clean, dry, flat and 1/4” larger
than the canopy on all sides. Any gaps between the mounting
surface and canopy exceeding 3/16” should be corrected as
required.
12) With silicone caulking compound, caulk completely around
where back of canopy meets the wall surface to prevent
water from seeping into outlet box.
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
Date Issued: 12/4/15 IS-49499-US
THREADED CAP
TAPA ROSCADA
SEE OTHER SIDE FOR SPANISH TRANSLATIONS.
VEA EL OTRO LADO DE TRADUCCIONES AL ESPAÑOL.
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
MOUNTING
BRACKET
MÉNSULA PARA
MONTAR
ROOF
TECHO
SCREW
TORNILLO
GLASS
VIDRIO
CAGE
JAULA