Installation Sheet

INSTALLING THE MOTOR HOUSING
NOTE: Before continuing , make sure the power is disconnected by turning
o the circuit breaker of removing the fuse at the circuit box.
Step 1. Align the tabs inside the motor housing with the slots on the mounting
plate cover. Screw the motor housing onto the mounting plate cover clockwise.
Fig. 13
Fig. 12
52" Chiara LED
11
ATTACHING THE FAN BLADES
NOTE: Before continuing , make sure the power is disconnected by turning
o the circuit breaker of removing the fuse at the circuit box.
Step 1. Position the blade over the blade bracket with threaded posts showing.
Make sure the bottom edge of the blade is fully seated against the blade bracket.
With a Phillips screwdriver, start a blade screw and washer into the blade
bracket (do not tighten) and repeat for the 2 remaining blade screws and
washers. Tighten each screw securely starting with the center screw. Make
sure the blade is straight. Repeat steps for the remaining blades. (Fig. 13)
Housing group
Mounting Plate
Cover
Slot
Tab
Blade Bracket
Screw
Fiber Washer
Blade