Instruction Sheet

10) Make wire connections (connectors not provided). Reference chart below
for correct connections and wire accordingly.
11) Pushxturetoceiling,carefullypassingmountingscrewsthroughholes
in canopy.
12)Securexturetoceilingwiththreadedballs.
13) Set glass then spacer down over socket.
14) Attach socket ring to socket ring tool.
15) Lower socket ring tool with socket ring attached down through glass.
Thread socket ring onto socket. Tighten socket ring to secure glass in
place. (DO NOT over tighten.)
16) Insert supplied bulbs. CAUTION: DO NOT touch bulb with bare hands. If
  thishappens,cleanbulbwithdenaturedalcoholandalintfreecloth.
17) Thread glass sleeves onto sockets. (DO NOT over tighten.)
LOOP/CHAIN LINK MOUNT
1) Followsteps1-3fromRigidStemMountInstructions.
2) Screwthreadedpipeintoendofeachstem.
3) Screw loops onto end of each threaded pipe.
4) Add one chain link to each loop and add second loop to each chain link.
5) Screw threaded pipe into end of each loop.
6) Pass each threaded pipe on loops through holes in canopy.
7) Slip one lockwasher over end of each threaded pipe and screw one
 hexnutontothreadedpipes.
8) Followsteps6-17fromRigidStemMountInstructions.
IMPORTANT SAFETY INSTRUCTIONS
LIGHTED BULB IS HOT!
WARNING: To reduce the risk of FIRE or INJURY TO PERSON:
• Turnoffandallowtocoolbeforereplacingbulb.
•BulbgetsHOTQUICKLY!Contactswitchonlywhenturningoff.
•DONOTremaininlightifskinfeelswarm.(Lightisintense,maycause
“sunburn”)
•DONOTlookdirectlyatlightedbulb.
•Keepmaterialsawayfrombulbthatmayburn.
•UseONLYwithwattagespeciedorlower.
•DONOTtouchbulbatanytime,useasoftcloth.Oilfromskinmaydamage
bulb.
•DONOToperatexturewithmissingordamagedglass
RIGID STEM MOUNT
1) Lowershadedownoverxture.Setshadedownonarmsofxture.
2) Passwirethroughstemsandscrewstemsintocouplingsontopof
 xturebody.IMPORTANT:Atleastone12”stemmustbeusedoneach
coupling.
NOTE: Threadlockingcompoundmustbeappliedtoallstemthreads
 asnotedwithsymbol(3)topreventaccidentalrotationofxtureduring
 cleaning,relamping,etc.
3) Passxturewirethroughremainingstemsandscrewstemstogether.
4) Passholesincanopyoverendsofstems.
5) Sliplockwasheroverendofeachstemandscrewhexnutontoendof
 eachstem
6) TURN OFF POWER.
IMPORTANT:Beforeyoustart,NEVERattemptanyworkwithout 
shutting off the electricity until the work is done.
 a) Gotothemainfuse,orcircuitbreaker,boxinyourhome.Place
  themainpowerswitchinthe“OFF”position.
 b) Unscrewthefuse(s),orswitch“OFF”thecircuitbreakerswitch(s),
  thatcontrolthepowertothextureorroomthatyouareworking
on.
 c) Placethewallswitchinthe“OFF”position.Ifthexturetobe
  replacedhasaswitchorpullchain,placethoseinthe“OFF”
position.
7) Findtheappropriatethreadedholesonmountingstrap.Assemble
 mountingscrewsintothreadedholes.
8) Attachmountingstraptooutletbox.(Screwsnotprovided).Mounting
 strapcanbeadjustedtosuitpositionofxture.
9) Groundinginstructions:(SeeIllus.AorB).
 A) Onxtureswheremountingstrapisprovidedwithaholeandtwo
  raiseddimples.Wrapgroundwirefromoutletboxaroundgreen
  groundscrew,andthreadintohole.
 B) Onxtureswhereacuppedwasherisprovided.Attachground
  wirefromoutletboxundercuppedwasherandgreenground
  screw,andthreadintomountingstrap.
 Ifxtureisprovidedwithgroundwire.Connectxturegroundwireto
 outletboxgroundwirewithwireconnector(notprovided.)afterfollowing
the above steps. Never connect ground wire to black or white power
supply wires.
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
Date Issued: 9/23/11 IS-42920-US
GREEN GROUND
SCREW
CUPPED
WASHER
A
B
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
(NOT PROVIDED)
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
THREADEDBALL
BOLAROSCADO
LOOP/CHAIN LINK
LAZO/ ESLABÓN DE CADENA
CANOPY
ESCUDETE
LOCKWASHER
ARANDELA DE
SEGURIDAD
STEM
VARILLA
HEXNUT
TUERCAHEXAGONAL
LOOP
ANILLO
CHAINLINK
ESLABÓNDE
CADENA
STEM
VARILLA
RIGID STEM MOUNT
MONTAJE DEL VÁSTAGO NERVADO
3
3
3
MOUNTING STRAP
PLANCHAPARAMONTAR
SHADE
PANTALLA
SPACER
ESPACIADOR
GLASSSLEEVE
CAMISADE
VIDRIO
BULB
BOMBILLA
SOCKETRINGTOOL
HERRAMIENTADEL
ANILLO DEL
CASQUILLO
SOCKETRING
ANILLO DEL
CASQUILLO
GLASS
VIDRIO
ARM
BRAZO
SEE OTHER SIDE FOR SPANISH TRANSLATIONS.
VEA EL OTRO LADO DE TRADUCCIONES AL ESPAÑOL.