Installation Sheet

CAUTION – RISK OF SHOCK – Disconnect Power at the main
circuit breaker panel or main fuse box before starting and during
the installation.
1) Pass fixture electrical wire and ground wire through desired
amount of stems D & E and screw together using supplied
threaded nipples into coupler on top of fixture. NOTE: one
(1) 12 inch stem minimum is required during mounting for
safety.
2) Screw in two (2) canopy mounting screws into the mounting
strap and connect mounting strap to outlet box.
3) Connect the two (2) loops, chain link with two (2) threaded
nipples to the canopy using the lockwasher and hexnut
supplied.
4) Route wires and ground wire through chain link and through
canopy into the electrical box. Connect the D & E stems to
the lower loop.
5) Grounding instructions: (See Illus. A or B).
A) On fixtures where mounting strap is provided with a hole
and two raised dimples. Wrap ground wire from outlet
box around green ground screw, and thread into hole.
B) On fixtures where a cupped washer is provided. Attach
ground wire from outlet box under cupped washer and
green ground screw, and thread into mounting strap.
If fixture is provided with ground wire. Connect fixture
ground wire to outlet box ground wire with wire connector
(not provided.) after following the above steps. Never
connect ground wire to black or white power supply wires.
6) Make wire connections. Reference chart below for correct
connections and wire accordingly.
7) Use the (2) two ball knobs and two (2) lockwashers to secure
canopy after wire connections are completed per below.
8) Install approved bulb, item C, not supplied.
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
A
B
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
Date Issued: 05/30/2017 IS-43794-US
SEE OTHER SIDE FOR SPANISH TRANSLATIONS.
VEA EL OTRO LADO DE TRADUCCIONES AL ESPAÑOL.
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
MOUNTING SCREWS
OUTLET BOX
MOUNTING STRAP
STRAP MOUNTING SCREWS
WIRE CONNECTORS
(2) LOCK-UP KNOBS
(2) LOCKWASHER
LOOP
NIPPLE
LOOP
LOCKWASHER
HEXNUT
CANOPY
CHAIN LINK
D
E
C
BULB NOT
INCLUDED
E
**MINIMUM OF ONE 12" STEM
REQUIRED FOR MOUNTING.**