Installation Guide

Date Issued: 06/22/16 IS-43893-US
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main fuse
box before starting and during the installation.
1) Pass fixture wire from the stem through the hole in the bot-
tom of the canopy. Pass the top of the stem through the
hole.
2) Slip lockwasher onto the threaded end of the stem protrud-
ing from the canopy. Thread nut onto end of stem. Tighten
nut to secure fixture to canopy.
3) Insert recommended bulbs (Not supplied)
4) Attach each bead strand onto holes located on bottom side
of center ring. (you may need to pinch with needle nose pli-
ers to secure hook). Attach other end onto holes of top side
of center ring.
5) Attach other end of beads onto holes of top side of bottom
trim.
6) Find the appropriate threaded holes on mounting strap.
Assemble mounting screws into threaded holes.
7) Attach mounting strap to outlet box.
Mounting strap can be adjusted to suit position of fixture.
8) Grounding instructions: (See Illus. A or B)
A) On fixtures where mounting strap is provided with a hole
and two raise dimples. Wrap ground wire from outlet
box around green ground screw, and thread into hole.
B) On fixtures where a cupped washer is provided. Put
ground wire from outlet box under cupped washer and
green ground screw and thread screw into hole in
mounting strap.
If fixture is provided with ground wire. Connect fixture
ground wire to outlet box ground wire with wire connector,
after following the above steps. Never connect ground wire
to black or white power supply wires.
9) Make wire connections. Reference chart below for correct
connections and wire accordingly.
10) Push fixture to ceiling, carefully passing mounting screws
through holes in canopy.
11) Thread lock-up knobs onto ends of mounting screws.
Tighten lock-up knobs to secure fixture to ceiling.
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
A
B
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
OUTLET BOX
WIRE
CONNECTOR(S)
STRAP
MOUNTING
SCREWS
MOUNTING
STRAP
MOUNTING
SCREWS
HEXNUT
LOCKWASHER
CANOPY
CENTER
RING
LOCKWASHER
LOCK-UP
KNOBS
STEM
BEAD
STRAND
SOCKET
BOTTOM TRIM