Installation Guide

ASSEMBLY INSTRUCTIONS

3. Position threaded nipple (C) in mounting bracket

(B) so that, when mounted:

• The threaded nipple (C) will protrude a

minimum of ¼ inch beyond the raised center

portion of the bracket (B).

• The threaded nipple (C) height should be

positioned so that ½ the exterior threads of

the screw collar loop (I) will extend past the

canopy (A), when it is mounted.

Note: Canopy is only needed to

determine the position of the threaded nipple

and fixture loop. It will be installed later.

1. Lower decorative cap (F) over coupling (J) and

secure with fixture loop (L).

2. raise decorative ring (N) to Arms (M). Insert

stand-offs on the decorative ring (N) into the

predrilled holes on the arms (M).

Note: The electrical cable will need to get pulled

through the individual parts as they are installed

on this and later steps.

1/4 Inch