Installation Guide

ASSEMBLY INSTRUCTIONS
6
7. Pass canopy (A) over the screw collar loop (I).
Screw the screw collar ring (H) onto the screw
collar loop (I) to secure canopy (A).
7
H
I
A
8a
K
K
8b
CORRECT
INCORRECT
8. To open chain links:
Locate the split in the chain link (K) you're
removing. Put one pair of pliers (not included) on
each side of the split and rotate the pliers in
opposite directions to open the link's split. The open
link should be shaped like the letter "C".
Do not twist the ends of the link sideways so that
the open link cannot lay flat.
9. Using the open chain links on chain (K), attach one
end to screw collar loop (I) and the other end to
threaded loop (J). Weave the fixture electrical and
ground wires through every other chain link and
pass through threaded nipple (C) into outlet box.
Then lower the screw collar ring (H) and canopy (A)
over the chain (K).
CAUTION: To avoid damage from falling, make
sure the open chain links are fully closed once
assembled.
J
H
A
K
I
C
9
Outlet
Box