Specification Sheet

Kichler.com
0-10V Dimmable Power Supply
EMC Compliance
Conducted and Radiated EMI
FCC CFR Title 47 Part 15 Class B at 120 VAC and FCC CFR Title 47 Part 15 Class A at 277 VAC
Harmonic Current Emissions
IEC61000-3-2 -
Voltage Fluctuations & Flicker
IEC61000-3-3 -
Immunity
Compliance
ESD (Electrostatic
Discharge)
IEC61000-4-2 6kV contact discharge, 8kV air discharge, level 3
RF Electromagnetic
Field Susceptibility
IEC61000-4-3
3V/m, 80 - 1000 MHz, 80% modulated at a distance of 3 meters
Electrical Fast
Transient
IEC61000-4-4 +/- 2kV on AC power port for 1 minute, +/- 1kV on signal/control lines
Surge IEC61000-4-5
+/- 1kV line to line (dierential mode) / +/- 2kV line to common mode ground
(tested to secondary ground) on AC power port, +/- 0.5kV for output cables
Conducted RF
Disturbances
IEC61000-4-6 3V, 0.15-80MHz, 80% modulated
Voltage Dips IEC61000-4-11 >95% dip, 0.5 period; 30% dip, 25 periods; 95% reduction, 250 periods
Transient Protection Ring Wave
-
ANSI/IEEE c62.41.1-2002 & c62.41.2-2002 category A, 2.5kV ring wave
Safety Agency Approvals
ETL
Conforms to ANSI/UL 2108
cETL Certified to CAN/CSA Std. C22 No. 9.0
Safety
Units Minimum Typical Maximum Notes
Hi Pot (High Potential) or
Dielectric Voltage-Withstand Vdc 2500 - -
• Insulation between the input (AC line and Neutral) and the output
• Tested at the RMS voltage equivalent of 1768 VAC
5 - EMC COMPLIANCE AND SAFETY APPROVALS
6 - PROTECTION FEATURES
• Under-Voltage (Brownout)
The Power Supply provides protection circuitry such that an application of an input voltage below the minimum stated in
paragraph 1 (Input Specification) shall not cause damage to the driver.
• Short Circuit
The Power Supply is protected against short circuit such that a short from any output to return shall not result in a fire hazard
or shock hazard. The driver shall hiccup as a result of a short circuit or over current fault. Removal of the fault will return the
driver to within normal operation. The driver shall recover, with no damage, from a short across the output for an indefinite
period of time.
• Internal Over Temperature Protection
The Power Supply incorporates circuitry that prevents internal damage due to an over temperature condition. An over
temperature condition may be a result of an excessive ambient temperature or as a result of an internal failure. When the over
temperature condition is removed, the driver shall automatically recover.
• Output Over-Voltage Protection
The output voltage of the Power Supply is limited to +5% of the rated output voltage of each model.