LIVIN’ LOUD ZX AMPLIFIER ZX350.4 ZX650.4 English Version Versión Español Amplificador del la Serie ZX.4 Deutsche Version Stereoverstärker der ZX.4-Serie Version Francaise Amplificateur de série ZX.
ZX.4-SERIES AMPLIFIERS Owner’s Manual MODEL: ZX350.4 / ZX650.4 Authorized KICKER Dealer: Purchase Date: Model Number: Serial Number: PERFORMANCE Model: ZX350.4 ZX650.4 RMS Power, all channels driven @ 14.4V, 4 stereo, d 1% THD+N @ 14.4V, 2 stereo, d 1% THD+N @ 14.
the source unit and connect the wire to the RCA Inputs on the end panel of the amplifier or simplify the installation by using a KICKER ZISL as shown below. Keep the audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring, cross it at a 90 degree angle.
BRIDGED OPERATION (MONO) minimum impedance of 4 ohms signal in L+ L- R+ R- L+ L- R+ RL R L AMP1 R AMP2 AMP1 AMP2 L+ L- R+ R- L+ BRIDGE WIRING R- L+ L- R+ R- woofer woofer STEREO-AND-MONO-SIMULTANEOUSLY (SAMS) OPERATION minimum impedance of 4 ohms bridged (mono) and 2 ohms per channel stereo signal in L+ L- R+ R- L+ L- R+ RL R AMP1 L R AMP2 AMP1 AMP2 L+ L- R+ R- L+ BRIDGE WIRING R- L+ L- R+ R- woofer ZXRC* REMOTE BASS INSTALLATION 2.
OPERATION AUTO TURN ON +12V INPUT LEVEL DC AUDIO LO OFFSET HI L R L R FADER XOVER1 OFF ON AMP1 OFF AMP2 HI LO XOVER2 OFF HI LO REMOTE BASS AMP1 AMP2 L+ L- R+ R- L+ BRIDGE WIRING R- L+ L- R+ R- Automatic Turn-On Selection: The ZX series offers three different automatic turn-on modes that can be selected on the end panel; +12V, DC Offset, and Audio. Using either the DC Offset or Audio mode causes the REM terminal to have +12V out for turning on additional amplifiers.
TROUBLESHOOTING If your amplifier does not appear to be working, check the obvious things first such as blown fuses, poor or incorrect wiring connections, incorrect setting of crossover switch and gain controls, etc. There is an illuminated red badge on top of the amplifier denoting the power state of the amp in addition to the Protection LED on the end panel of your KICKER ZX series amplifier. When the red badge is lit, this indicates the amplifier is turned on and the amplifier is functioning properly.
CAUTION: When jump starting the vehicle, be sure that connections made with jumper cables are correct. Improper connections can result in blown amplifier fuses as well as the failure of other critical systems in the vehicle. If you have more questions about the installation or operation of your new KICKER product, see the Authorized KICKER Dealer where you made your purchase. For more advice on installation, click on the SUPPORT tab on the KICKER homepage, www.kicker.com.
ELECTRONICS LIMITED WARRANTY KICKER warrants this product to be free from defects in material and workmanship under normal use for a period of THREE (3) MONTHS from date of original purchase with receipt. When purchased from an Authorized KICKER Dealer it is warranted for TWO (2) YEARS from date of original purchase with receipt. In all cases you must have the original receipt.
INTERNATIONAL WARRANTY Contact your International KICKER dealer or distributor concerning specific procedures for your country’s warranty policies. WARNING: KICKER products are capable of producing sound levels that can permanently damage your hearing! Turning up a system to a level that has audible distortion is more damaging to your ears than listening to an undistorted system at the same volume level.
©2009 Stillwater Designs
