Owner's Manual

ManualsBrandsKicker ManualsAmplifiersKicker 2004 SX400.2 | SX500.2| SX600.2 | SX900.2 Amplifier

SX .2 Series Amplifiers

Operation

hi-pass MENU - Here is where you adjust the high pass

crossover.

Press the

ENT key to enter the

HI-PASS menu.

Use the

UP and DOWN keys to

scroll through

frequency and slope

and press the ENT to select the one

you want to adjust.

FREQUENCY selects the crossover point and can be set at any

1/12th octave frequency from 10 Hz to 16 kHz.

(

10 Hz to 16132 Hz)

Use the

UP and DOWN keys to

select your frequency. Press the

ESC

key to return to the HI-PASS menu.

SLOPE selects the rolloff of the crossover and can be set

from

OFF to 36 dB in 6 dB steps.

Use the

UP and DOWN keys to

select your slope. Press the

ESC

to return to the HI-PASS menu.

When you are done adjusting the

EQ press the

ESC key while in the

EQ menu to return to the MAIN

menu.

NOTE...

While adjusting the HI-PASS crossover you will notice the

hpf indicator on the ISIS VFD display is lit. This indicates

you are in the HI-PASS crossover menu.

The KICKER SX amplifier monitors and prevents any high

pass crossover point from being any closer than 1/3 octave

from the low pass crossover point. If you cannot set the high

pass crossover where you want then check the

LPF indicator

and see if it is flashing. If it is then you need to go to the

LO-PASS menu and lower the low pass crossover point.

This is done as a safety precaution to prevent a notch

filter condition.

HOME

ENT

ESC

HOME

ENT

ESC

HOME

ENT

ESC

HOME

ENT

ESC

HOME

ENT

ESC

SX .2 Series Amplifiers

Operation

Lo-Pass MENU - Here is where you adjust the low pass

crossover.

Press the

ENT key to enter the

LO-PASS menu.

Use the

UP and DOWN keys to

scroll through

frequency and

slop[e. Press the ENT to select the

one you want to adjust.

FREQUENCY selects the crossover point and can be set at any

1/12th octave frequency from 30 Hz to 20 kHz.

(

30 Hz to 20325 Hz)

Use the

UP and DOWN keys to

select your frequency. Press the

ESC to return to the LO-PASS

menu.

SLOPE selects the rolloff of the crossover and can be set

from

oFF to 36 dB in 6 dB steps.

Use the

UP and DOWN keys to

select your slope. Press the

ESC to

return to the LO-PASS menu.

When you are done adjusting the

EQ press the

ESC key while in the

EQ menu to return to the MAIN

menu.

NOTE...

While adjusting the LO-PASS crossover you will notice the

LPF indicator on the ISIS VFD display is lit. This indicates

you are in the LO-PASS crossover menu.

The KICKER SX amplifier monitors and prevents any low pass

crossover point from being any closer than 1/3 octave from

the high pass crossover point. If you cannot set the low pass

crossover where you want then check the

HPF indicator and

see if it is flashing. If it is then you need to go to the HI-PASS

menu and raise the high pass crossover point.

This is done as a safety precaution to prevent a notch filter

condition.

HOME

ENT

ESC

HOME

ENT

ESC

HOME

ENT

ESC

HOME

ENT

ESC

HOME

ENT

ESC