Owner's Manual

Fuses:

2 x 15 Amperes

Automatic Turn-On Selection: KICKER powered enclosures offer three different automatic turn-on modes

that can be selected on the side panel; +12V, DC Offset, and Audio. Using either the DC Offset or Audio mode

causes the REM terminal to have +12V out for turning on additional ampliﬁ ers.

• Remote Turn-On: Set the switch to +12V to use the remote turn-on lead from your source unit. Run 18

gauge wire from the Remote Turn-On Lead on your source unit to the terminal labeled REM on the quick-

connect power harness. This is the preferred automatic turn-on method.

• DC Offset Turn-On: If Remote Turn-On is not an option, the next best setting is DC Offset. The DC Offset

mode detects a DC offset from the HI-Level speaker outputs when the source unit has been turned on.

• Signal Sense Turn-On: The Audio setting is the ﬁ nal alternative for Automatic turn-on. This is a Signal Sense

turn-on method that detects the incoming audio signal from your source unit and automatically turns on

your powered enclosure. This turn-on method will not work properly if the input gain control is not set

appropriately.

GND REM +12V

GAIN

BASS

BOOST(dB)

PWR/PRT

INPUT REMOTE

BASS

AUTO

TURN ON

PHASE

REM

DC OFFSET

AUDIO 180° HI

LO0°

INPUT

LEVEL

X-OVER

FREQ.(Hz)

2011 PES10C - PECVR12 RevE.indd 52011 PES10C - PECVR12 RevE.indd 5 9/14/2010 1:55:53 PM9/14/2010 1:55:53 PM