(fKICKER DX.1-SERIES AMPLIFIERS OWNER 1S MANUAL DXA250.1 MODEL: I DXA500.1 Authorized KICKER Dealer: Purchase Date: Model Number: Serial Number: PERFORMANCE Model: AMS Pow~r [VVa~~l @ l4.4V~ @ 40 mono, l4.
to amplifier core conductor source unit high-level speaker outputs + . . . . .- = )-1 OR to amplifier from source unit highlevel speaker outputs Install a fuse within 18" (45cm) of the battery and in-line with the power cable connected to your amplifier. If you ever need to remove the amplifier from the vehicle after it has been installed, the ground wire should be the last wire disconnected from the amplifier--just the opposite as when you installed it.
For multiple amplifier installations where distribution blocks are used, each amplifier should have its proper-rated fuse, or breaker, installed between the amplifier and the distribution block within eighteen inches of the block, or on the distribution block if it provides for fusing.
OPERATION @ INPUT OUTPUT INPUT LEVEL _a_w GAIN X-OVER BASS REMOTE FREQ(Hz) BOOST(dB) BASS ~~~0 0 11 50 200 0 (f) PRT (DPWR 12 ---HI R Automatic Turn-On Selection: The DX series offers two automatic turn-on modes; + 12V and DC Offset. • Remote Turn-On: Run 18 gauge wire from the Remote Turn-On Lead on your source unit to the terminal labeled REM between the amplifier's positive and negative power terminals.
CXARC REMOTE BASS INSTALLATION Surface-mount the CXJ\RC remote using the supplied screws. back vi ew Remote cable passes audio; do not run cable parallel to power wires . Con nect the suppli ed 1/8th inch [3.5mm] patch cable to the CMRC remote and the Remote Bass jack on the amplifier. TROUBLESHOOTING If your amplifier does not appear to be working, check the obvious things first such as bl own fuse s, poor 9r incorrect wiring connection s, incorrect setting of crossover switch and gain controls, etc.
Ground Noise? KICKER amplifiers are engineered to be fully compatible with all manufacturers' head units. Some head units may require additional grounding to prevent noise from entering the audio signal. If you are experiencing this problem with your head unit, in most cases running a ground wire from the RCA outputs on the head unit to the chassis will remedy this issue. CAUTION: When jump starting the vehicle, be sure that connections made with jumper cables are correct.
ELECTRONICS LIMITED WARRANTY When purchased from an Authorized KICKER Dealer, KICKER warrants this product to be free from defects in material and workm anship under normal use for a period of TWO (2) YEARS from date of original purchase with receipt. If this product is identified as "Refurbished" or "8 Good s", the warranty is limited to a period of THREE (3) MONTHS from the date of original purchase. In all cases you must have the original receipt.
INTERNATIONAL WARRANTY Contact your International KICKER dealer or distributor concerning specific procedures for your country's warranty policies. WARNING: KICKER products are capable of producing sound levels that can permanently damage your hearing! Turning up a system to a level that has audible distortion is more damaging to your ears than listening to an undistorted system at the same volume level.
