User Manual

D. Cut out the OUTSIDE template (Driver/Passenger) along the cut line. Position the template on the outside footwell. Make sure the

bottom of the template lines up along the bottom edge and tab of the factory panel as shown in  gure D1-D3. Using a scribing tool,

mark the center of the 2 drill points illustrated on the template as shown in D4 and D5. When marking these holes, make sure the

template is ﬂ ush against the factory panel.

C. Drill a pilot hole at the places just marked with a 1/8” drill bit. Then follow up by using a 1/4” drill bit in the lower pilot hole (for

mounting the pod) and a 1/2” drill bit in the upper pilot hole (for speaker cable).

E1 D3D1 D2