Manualshelf

User Manual

ManualsBrandsKICKER ManualsCar AudioKICKER - CanAm X3 Phase 5, Kicker/SSV Works 5 Speaker Vehicle Specific Solution - Black
11121314151617181920
16
A. Apply the foam strips to the inside right, left and top side of
the enclosure.
C. Remove the factory 10mm nut and bolt from the brake line. Place the washer on top of the factory bracket and push the long M6x25mm screw through
the top. Then attach the brake line, spacer, washer and nut. T hen hand tighten.
B. Using the supplied M6 screws and washers, screw the DD-brackets
to the bottom right and left side of the enclosure.
D. Replace the factory seat bolt spacers with the supplied SSV
Works spacers
E. Run the brake line along the dedicated channel on the sub enclosure while feeding
the enclosure down under the seat bar (F1). Make any adjustments to the brake
line so the enclosure lays on top of it. Line up the rear enclosure brackets to the
rear seat bolts and press down until the brackets rest on top of the spacers.
A
B
C C C
D
E1
E2