User Manual

6
RUNNING AMP POWER CABLE AND SPEAKER WIRE
I1 I2
I. In this step you will be feeding all of the necessary wires from the top drivers side dash down the center dash column. Be sure to run all of
the wires along side the factory cabling to avoid any moving parts. Feed both amp power wires, rear speaker expansion harness, subwoofer
harness, and power/ground for MRB3 from top driver side down the center column (I1). Pull all wires through the bottom center column and
across the center console with the factory wiring (I2).
J. Run rear expansion harness through rear center console cavity, following the
factory cables. If you are installing a 3-speaker kit, simply zip tie the cable
to a factory harness as this step is completed. If installing a 5-speaker kit,
please refer to the installation of the Cage Mounted Speakers.
H. Connect the MRB3 Power into the WP-H16PG84-6. Using the butt splice
terminals on the WP-H16PG84-6, connect black to black and red to yellow.
J
H
The connection of each cable will be address further along in the instructions.
WP-H16PG84-6
MRB3 Power Connector