KMA600.1 KMA AMPLIFIERS Owner’s Manual Manual del Propietario | Español AMPLIFICADOR DEL LA SERIE KMA.1 Benutzerhandbuch | Deutsch MONOVERSTÄRKER DER KMA.1-SERIE Manuel d’utilisation | Française AMPLIFICATEUR DE SÉRIE KMA.
KMA.1-SERIES AMPLIFIERS OWNER’S MANUAL MODEL: KMA600.1 IMPORTANT SAFETY WARNING PROLONGED CONTINUOUS OPERATION OF AN AMPLIFIER, SPEAKER, OR SUBWOOFER IN A DISTORTED, CLIPPED OR OVER-POWERED MANNER CAN CAUSE YOUR AUDIO SYSTEM TO OVERHEAT, POSSIBLY CATCHING FIRE AND RESULTING IN SERIOUS DAMAGE TO YOUR COMPONENTS AND/OR VEHICLE. AMPLIFIERS REQUIRE UP TO 4 INCHES (10CM) OPEN VENTILATION. SUBWOOFERS SHOULD BE MOUNTED WITH AT LEAST 1 INCH (2.5CM) CLEARANCE BETWEEN THE FRONT OF THE SPEAKER AND ANY SURFACE.
source unit high-level speaker outputs KICKER KISL (optional) to amplifier core conductor + OR – to amplifier shield from source unit highlevel speaker outputs Install a fuse within 7” (18cm) of the battery and in-line with the power cable connected to your amplifier. Model External Fuse Power/Ground Wire KICKER Wiring Kit 4 Gauge PK4, CK4 (sold separately) KMA600.
For multiple amplifier installations where distribution blocks are used, each amplifier should have its proper-rated fuse, or breaker, installed between the amplifier and the distribution block within seven inches of the block, or on the distribution block if it provides for fusing.
OPERATION Automatic Turn-On Selection: The KMA series offers two different automatic turn-on modes; +12V and DC Offset. • Remote Turn-On: Run 18 gauge wire from the Remote Turn-On Lead on your source unit to the terminal labeled REM between the amplifier’s positive and negative power terminals. This is the preferred automatic turn-on method. • DC Offset Turn-On: The DC Offset mode detects a 6V DC offset from the HI-Level speaker outputs when the source unit has been turned on.
KMARC REMOTE BASS INSTALLATION Surface-mount the KMARC remote using the supplied screws. back view Remote cable passes audio; do not run cable parallel to power wires. Connect the cable to the KMARC remote and the Remote Bass connection on the amplifier TROUBLESHOOTING If your amplifier does not appear to be working, check the obvious things first such as blown fuses, poor or incorrect wiring connections, incorrect setting of crossover switch and gain controls, etc.
Ground Noise? KICKER amplifiers are engineered to be fully compatible with all manufacturers’ head units. Some head units may require additional grounding to prevent noise from entering the audio signal. CAUTION: When jump starting the battery, be sure that connections made with jumper cables are correct. Improper connections can result in blown amplifier fuses as well as the failure of other critical systems in the vehicle.
ELECTRONICS LIMITED WARRANTY When purchased from an Authorized KICKER Dealer, KICKER warrants this product to be free from defects in material and workmanship under normal use for a period of TWO (2) YEARS from date of original purchase with receipt. If this product is identified as “Refurbished” or “B Goods”, the warranty is limited to a period of THREE (3) MONTHS from the date of original purchase. In all cases you must have the original receipt.
INTERNATIONAL WARRANTY Contact your International KICKER dealer or distributor concerning specific procedures for your country’s warranty policies. WARNING: KICKER products are capable of producing sound levels that can permanently damage your hearing! Turning up a system to a level that has audible distortion is more damaging to your ears than listening to an undistorted system at the same volume level.
Company Name: Grupo Monsiry S. de R.L. de C.V. Address: Ave. Baburias #14171 int. B Fracc. Jose Sandoval Tijuana, B.C.
