Owner's Manual

9English
Setting Input Source
Short Press the SOURCE button to switch between
Bluetooth (blue) and AUX IN (red) input sources.
To enter Bluetooth Pairing Mode, Long Press the
SOURCE button while in Bluetooth mode. The
STATUS LED will begin to flash blue. You may exit
pairing mode at this stage by short pressing the
SOURCE button.
To finish pairing, from your audio device select either
‘KPB1 KICKER’ or ‘KPB2 KICKER’. When successfully
connected, the STATUS LED will be solid blue. When
the PowerBar powers on in, or enters, Bluetooth
mode, it will automatically begin to search for and
connect with the last connected device. If that device
is not found, it will continue to search for other saved
connections until a connection is established.
Broadcast Mode
Broadcast Mode allows you to play your audio
through two KPBs. One KPB, the Primary, will
broadcast the audio to the Secondary KPB. EQ
settings applied by the Primary will be mirrored on the
Secondary. Broadcast Mode is compatible with both
audio input sources. You may enter Broadcast Mode
with the following button sequence.
1. Set audio input source with the Primary KPB.
2. Simultaneously Press & Hold the PLAY/PAUSE
button and the Increase Volume button on the Primary
KPB. The Status LED will begin alternately flashing
blue and red.
3. Simultaneously Press & Hold the PLAY/PAUSE
button and the Decrease Volume button on the
Secondary KPB.