Owner's Manual

5English
Keep the audio signal cable away from factory wiring
harnesses and other power wiring. If you need to
cross this wiring, cross it at a 90-degree angle.
Mounting
The KPB-series mounts natively to bar cylinders with
included bar clamp diameter sizes of 1.5”, 1.75”, and
2”. Use the KPB Square Clamps (LINK GOES HERE)
- sold separately - to mount your KPB to square
bars. Choose a structurally sound location to mount
the KPB. The KPB may be mounted below or above
bars. Make sure there are no items interfering with the
route of the wiring. The KPB2 may be mounted above
or below the bars, while the Mounting Base may be
rotated ± 30° to accommodate some curved bars.
Installation tools are not provided. 5mm and 6mm
Allen Wrenches are required.
1. Screw the Mounting Bases to the PowerBar using
the Mounting Screws.