Owner’s Manual Manual del Propietario Manuel d’utilisatio Benutzerhandbuch KS COAX SPEAKERS Altavoz Coax KS KS Koax-System Haut-parleurs Coaxiaux KS
Contents Overview......................... 3 Specifications......................... 4 Installation....................... 5 Wiring.................................... 5 Mounting................................ 8 Warranty.......................
Overview IMPORTANT SAFETY WARNING PROLONGED CONTINUOUS OPERATION OF AN AMPLIFIER, SPEAKER, OR SUBWOOFER IN A DISTORTED, CLIPPED OR OVER-POWERED MANNER CAN CAUSE YOUR AUDIO SYSTEM TO OVERHEAT, POSSIBLY CATCHING FIRE AND RESULTING IN SERIOUS DAMAGE TO YOUR COMPONENTS AND/OR VEHICLE. AMPLIFIERS REQUIRE UP TO 4 INCHES (10CM) OPEN VENTILATION. SUBWOOFERS SHOULD BE MOUNTED WITH AT LEAST 1 INCH (2.5CM) CLEARANCE BETWEEN THE FRONT OF THE SPEAKER AND ANY SURFACE.
Specifications Model: KSC270 KSC350 KSC40 KSC460 KSC4100 KSC50 Speaker Design 1 - Way 2 - Way 2 - Way 2 - Way 2 - Way 2 - Way Woofer [in, mm] 2-3/4, 70 3-1/2, 89 4, 100 4x6, 100x160 4x10, 100x250 5-1/4, 130 Mid [in, mm] – – – – – – Tweeter [in, mm] – 1/2, 13 1/2, 13 1/2, 13 1/2, 13 3/4, 20 Rated Impedance [Ω] 4 4 4 4 4 4 Peak Power Handling [Watts] 100 100 150 150 150 150 Recommended Amplifier Power [Watts RMS] 15-50 15-50 15-75 15-75 15-75 15-75 Sensitivi
Installation Wiring We recommend using 16 gauge (or larger) wire. The KS Speakers are rated at 4 ohms and work with any source unit or amplifier designed to operate at a 4 ohm load. Make sure your source unit or amplifier is rated for 4 ohm operation.
PARALLEL WIRING Two KS Speakers wired in parallel to a single channel Total Impedance: 2 ohms + English - + - + - 6
SERIES WIRING Two KS Speakers wired in series to a single channel Total Impedance: 8 ohms + English - + - 7
Mounting The KICKER KSC speakers are designed for free-air applications and do not require a sealed enclosure for optimum performance. It is important to isolate the sound coming from the front of the speaker from the sound radiating from the back of the speaker. This is most easily accomplished by mounting the speakers in a vehicle’s factory locations or in a location with a semi-isolated rear chamber (like the rear deck of a car behind the rear seats).
These multi-bracket adapters will help accommodate the KS speakers in factory or custom locations. You may need to cut off parts or otherwise modify these adapters to fit your vehicle or application.
KS270 ADAPTER - GM/MOPAR KS270 ADAPTER - CHRYSLER/JEEP KS270 ADAPTER - TOYOTA/SUBARU English 10
Secure speaker to desired location door door panel speaker cut-out KS Speaker English 11
Warranty When purchased from an Authorized KICKER Dealer, KICKER warrants this product to be free from defects in material and workmanship under normal use for a period of TWO (2) YEARS from date of original purchase with receipt. If this product is identified as “Refurbished” or “B Goods”, the warranty is limited to a period of THREE (3) MONTHS from the date of original purchase. In all cases you must have the original receipt.
The RMA number must be clearly marked on the outside of the package. Please return only defective components. The return of functioning items increases your return freight charges. Nondefective items will be returned freight collect to you. For example, if a subwoofer is defective, only return the defective subwoofer, not the entire enclosure.
Garantía | Garantie Contact your International KICKER dealer or distributor concerning specific procedures for your country’s warranty policies. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage.