Introduction KS-Series Tweeters Owner’s Manual Models: KS25 / KS20 / KS13 Congratulations! Attention: Please record your purchase information in the area below. We recommend attaching the original sales receipt to this manual for future reference. If you require service on this speaker during the warranty period, you will need to provide this information and a copy of the original sales receipt to Kicker for validation of warranty repairs.
Newly Designed Passive Crossover Network allows detailed imaging and pin-point sound staging of the critical high frequencies. High-Power Tinsel Lead Wires eliminate broken leads and power loss, due to the common use of “insufficient-gauge” lead wires. Aluminum Dome Tweeter with Neodymium Magnet featured in the KS25 provides a smooth high frequency response with fast, detailed and spatially-correct imaging.
Specifications Performance Model: KS13 KS20 KS25 Speaker Design High Frequency Transducer High Frequency Transducer High Frequency Transducer Rated Impedance, ohm 4 4 4 DC Resistance, ohm 3 3 3 Sensitivity [SPLo], dB @ 1W, 1m 92 92 94 Resonance Frequency [fo], Hz 2970 1770 1560 Power Range, Watts RMS 6-75 6-95 6-150 Peak Power Handling, Watts 150 190 300 Effective Frequency Range, Hz 4500-21k 4500-21k 3500-22k Top-Mount Depth, in (cm) 9/16 (1.4) 9/16 (1.4) 15/32 (1.
Installation Installation Tweeter Mounting If custom door mounting locations for the KS-Series Tweeters are desired, be careful to avoid interference from the window and door lock mechanisms. The first step is to find a location on the door panel that will accept the dimensions of the speaker. Then remove the door panel from the door, and check for operational clearance of the window. Cycle the window all the way down and up. If metal must be cut to mount the speakers, avoid structural metal and braces.
Installation Installation all the parts in unison until the tweeter is angled in the desired direction. Secure the assembly by tightening the longer tweeter mounting nut, as outlined in Figure 5. Figure 4 Figure 3 Shorter Tweeter Mounting Nut Clearance Hole 2.5" Door Body Mounting Nut Wire Tweeter Door Panel Tweeter Panel 2" Hole Wiring There are two lengths of wires attached to the Kicker KS-Series Tweeter Crossover.
Acoustics LIMITED WARRANTY Kicker warrants this product to be free from defects in material and workmanship under normal use for a period of THREE (3) MONTHS from date of original purchase with receipt. When purchased from an Authorized KICKER Dealer it is warranted for ONE (1) YEAR from date of original purchase with receipt.