Amplifier Technical Manual

When AMP 1 or AMP 2 are driving speakers that do not require a crossover, the crossover switch may be set to the OFF position. This will allow the
speakers to play full range. OR... If AMP 1 or AMP 2 are driving speakers that do require a crossover set the
switch to HI PASS. This will allow only high frequencies to pass through
the amplifier to the speakers.
SIGNAL IN AMP 1 SIGNAL IN AMP 2
+
-
+
-
+
-
+
-
GROUND
REMOTE
TURN-ON
BATTERY
+12V
FUSE
18"
or less
+
-
To Left Speaker


-
-
To Right Speaker

-

-
To Right Speaker
To Left Speaker
KX200.4 4 Channel
Stereo Mode
System Diagrams
KX100.2 & KX200.4 Technical Manual
Version 2.0
Page 14