Owner's Manual

Installation Instructions
These enclosures combine KICKER’s award-winning Comp VR with comput-
er designed and human-fine-tuned enclosures. They offer a level of bass
performance never before thought possible from a commercially available
enclosure. The TC Series enclosures are covered in carpet for protection and
pre-loaded with a CompVR woofer.
KICKER TC enclosures are designed to fit behind the seat of a pickup truck.
They are engineered to provide the
best bass response when firing into
the back of the truck seat.
Plug your subwoofer speaker wires
into the terminals located on the back
of the box; the red connectors are
positive and the black connectors
negative. Hook the other end of these
wires to your subwoofer amplifier in
accordance with its owners’ manual;
note the enclosure is wired internally
to produce a 2 or 4 Ohm load at the
terminals depending on the model.
MModel
Woofer Imp. Power Top Bottom Height Width
Handling Depth Depth
(Watts) (In., cm) (In., cm) (In., cm) (In., cm)
TTCVVRR1100
C10VR *2,4 300
44
-1/2”,11.43
77
-3/4,19.69
1155
”, 38.1
2222
”, 55.88
NOTE:
*The two ohm unit should be used with the KX Series Class D amplifiers KX550.3, KX700.5, KX400.1,
and KX600.1. It is not recommended for use with any KX two or four channel amplifiers.
The four ohm unit should be used with any KX Series two or four channel amplifier. It is not rec-
ommended for use with any KX Series Class D amplifiers.
TCVR10
Sealed Enclosure Systems
Specifications
Congratulations! You have just purchased one of the most flexible subwoofers
yet from KICKER. Your CompVR sub is designed to give you great bass perform-
ance in a wide variety of applications. These installations instructions will help you
get the most out of your new KICKER sub. Thanks for buying KICKER. Enjoy!