MSDS

Document: ABC EXTINGUISHER
MSDS.DOC
Page 2 of 3
Reactivity in water:
Unreactive
Appearance and odor:
Odorless, pale colored fine powder (variable color)
Flash point:
N/A
Flammable limits in air,
% by volume
N/A
Auto-ignition
temperature:
N/A
Extinguishing media:
N/A – The product is a fire extinguishing agent
Unusual fire and explosion hazards:
NONE
Special fire fighting procedures:
The material is a fire extinguishing agent and will not burn. However, if other
materials are involved, use standard chemical fire fighting procedures and consider
the hazards of those materials. In enclosed areas, fire fighters must wear self-
contained breathing apparatus and full protective equipment.
Stability:
Stable
Conditions to avoid:
Extreme heat
Hazardous
polymerization:
Will not
occur
Incompatibility (materials to avoid):
Strong alkalis. Do not mix with BC type dry chemical extinguishing agents.
Hazardous decomposition products:
Ammonia, phosphorus oxides.
Threshold limit value:
ACGIH TLV for particulates not otherwise classified: 10 mg/m
3
OSHA PEL for nuisance dust limit total: 15 mg/m
3
Routes of entry:
Inhalation: YES; may be irritant to the respiratory tract.
Eye contact: YES; mildly irritant for a short period.
Skin contact: YES; may be mildly irritating.
Ingestion: NOT an expected route of entry.
Signs and symptoms of overexposure:
Acute: Transient cough, shortness of breath, irritation of airways.
Chronic: This product is not known to cause chronic illness.
Medical conditions generally
aggravated by exposure:
Asthma, emphysema, bronchitis or other respiratory illness.
Chemical listed as carcinogen or
potential:
NTP program: No IARC monographs: No OSHA: No
Emergency and first aid procedures:
Eye contact: Flush with large amounts of water for at least 15 minutes. If irritation
persists, seek medical attention.
Skin contact: Wash with soap and water. If irritation persists, seek medical attention.
Inhalation: Move victim to fresh air. Seek medical attention if discomfort continues.
Ingestion: Rinse mouth, drink large amounts of water and induce vomiting. Seek
medical help.
Precautions to be taken in handling
and storage:
Should be stored in original containers. Store in dry, cool, well-ventilated place away
from alkaline compounds. Wash after handling. Do not cut, grind, weld or drill on or
near product containers. Treat empty containers as if they were full.
Other precautions:
Do not mix with alkaline materials.
Steps to be taken in case materials is
released or spilled:
Sweep up or vacuum. Store in covered containers. Do not reuse. In case of large
spills, use rubber gloves, chemically resistant suit and boots, hard hat and air purifying
respirator.
Waste disposal method:
Dispose of in compliance with local, state and federal regulations. Components are
non hazardous, sanitary landfill disposal may be acceptable