Use and Care Manual

nect up to a total of 6 remote signaling devices and/or relay modules.

• When mixing models which have battery backup (i12040, i12040A, i12060,

i12060A, i12080, i12080A, i12090A, i4618, i4618A, i5000, 1275, 1276,

1285, 1296, PE120, PI2000, PI2010, KN-COSM-IB, RF-SM-ACDC, KN-COPE-I,

KN-SMFM-I, HD135, KN-COB-IC, KN-COP-IC) with models without battery

backup, (1235, i12020, i12020A, KN-COSM-I SM120X, CO120X SL177I) be

advised that the models without battery backup will not respond during an

AC power failure.

• The maximum wire run distance between the first and last unit in an intercon-

nected system is 1000 feet.

• Figure 4 illustrates interconnection wiring. Improper connection will result in

damage to the alarm, failure to operate, or a shock hazard.

• Make certain alarms are wired to a continuous (non-switched) power line.

NOTE: Use standard UL listed household wire (as required by local codes) avail-

able at all electrical supply stores and most hardware stores.

FIGURE 4 INTERCONNECT WIRING DIAGRAM

WIRES ON ALARM HARNESS CONNECTED TO

Black Hot Side of AC Line

White Neutral Side of AC Line

Red Interconnect Lines (Red Wires) of Other

Units in the Multiple Station Set up

BATTERY INSTALLATION (models i12040A and i12080A only)

See MAINTENANCE (section 6) for battery installation.

CAUTION! IF THE BATTERY REMINDER FINGER(S) ARE NOT HELD DOWN

IN THE BATTERY COMPARTMENT BY THE BATTERY, THE BATTERY DOOR

WILL NOT CLOSE, THE AC QUICK CONNECTOR WILL NOT ATTACH TO THE

ALARM, AND THE ALARM WILL NOT ATTACH TO THE TRIM RING (SEE

SECTION 6, FIGURE 9).

FUSE OR CIRCUIT BREAKER

REDBLACK

WHITE

BLACK

WHITE

RED

CONNECTOR

Kidde

Relay Module

SM120X

First

Alarm

Additional

Alarm

Optional

Accessory

Additional

Alarm

1220-7205-00(820-1183D-EN).qxd:_ 2010.9.3 7:04 PM Page 6